How to DIY Rain Barrel System

Tools You Need
1. Cordless drill 2. Hole saw, 2-1/4 in

Shopping List for Required Materials
55-gal. barrel with lid
4×4 treated lumber and construction screws or stainless steel lags, if you build a stand to elevate the rain barrel(s)
2-in. male threaded electrical (gray PVC) conduit adapter
2-in. female threaded electrical (gray PVC) conduit adapter
Silicone caulk, Glue, Screen, Threaded electrical PVC coupler
Sections of 2-in. PVC pipe, Unions reducers and valves, Close-up of conduit adapters
Use a 2-in. male threaded electrical (gray PVC) conduit adapter and a 2-in. female threaded conduit adapter to make a watertight hole from which the rainwater can flow.

Install valves
Install a large valve to quickly fill watering cans and a smaller valve for a garden hose. Secure the valves to the cross brace with J-brackets.

Figure A: Trash Can Rain Barrels
You can make cheap, functional rain barrels with trash cans and simple PVC plumbing and electrical conduit fittings. Line up as many as you need to meet your watering needs.

It’s pretty easy to build your own rain barrels from plastic drums or trash cans. Search online for “bottles” or “containers” to find an “open head” plastic 55-gallon drum with a cover (about $60). Or find a used barrel by talking to car wash managers (they buy soap and wax by the barrel). If you can’t find a container you like, buy a large, heavy-duty garbage can (about $35) at a home center. All the other plumbing parts will add up to about $40.

Place the drum near a downspout, drill a hole in the side near the bottom and screw in a drain valve. That’s an OK installation if you plan to run a soaker hose to your garden. But if you want to use a wand or a spray nozzle, you’ll need to elevate the barrel on a stand for more water pressure. Water is heavy (55 gallons weighs 440 lbs.), so use 4×4 treated lumber for the legs and secure everything with construction screws or stainless steel lags.

But don’t place the stand on soft ground. You could kill somebody if the rig toppled over. If you have large gardens and want to store more water, double-size the stand and add a second barrel.

Cut holes in the bottoms of the barrels with a 2-1/4-in. hole saw.

Then screw in a 2-in. male threaded electrical (gray PVC) conduit adapter (electrical adapters aren’t tapered like plumbing adapters, so you can tighten them down all the way).

Squirt a thin bead of silicone caulk around the opening and screw on a threaded electrical PVC coupler to cinch the barrel between the two fittings (see Figure A).

Next, glue together sections of 2-in. PVC pipe, unions (to make winter disassembly easier), reducers and valves.

As long as you’re at it, install an overflow pipe so you can direct the excess where you want it.

Finally, cut a hole in one of the covers and mount a screen to filter out leaves and debris.

Source: familyhandyman.com

Comments
One Response to “How to DIY Rain Barrel System”
Trackbacks
Check out what others are saying...
  1. […] make this even better, install a rain barrel and use that water for your trees at no […]



Leave A Comment